SCISSOR LIFT PX-3000XU
THIS IS AN IMPROVED VERSION OF THE PX-3000
WITH ADDITIONAL ENHANCEMENTS SUCH AS:
By using an additional "short scissor" on each cylinder, the lift works at full power from the bottom without causing trouble when lifting low sports cars, which is usually a problem for standard lifts
NEW LOCK SYSTEM FOR ACTUATORS
For complete safety and comfort of work, the pneumatic pawls have been transferred to the cylinders, so we can be sure that they will protect themselves every time, even in the event of uneven operation, when the center of gravity is not perfectly in the center of the lift.
In addition, they are affected by much less force than the latches that were placed on the bottom plate, which significantly increases safety at work.
REMOVED LOWER BAR
After anchoring the lift to the ground, we can remove one of the two lower synchronization crossbars. This enables trouble-free access from below to the supported vehicle, in particular it is useful when mounting the lift on the channel.
The ramp is only 10.5 cm high, so it's not a problem for low vehicles or vehicles with additional spoilers
Four ramps made of checkered sheet metal make entering the lift easy.
The possibility of blocking the ramps in a horizontal position allows the lift to be extended, which greatly facilitates work on longer vehicles with support points at a greater distance.
On blocked ramps, you can set rubber blocks and support the vehicle
It allows one person to quickly move the lift without load over a hardened surface.
Our lift meets all the expectations of demanding users.
Its solid reinforced construction will make it serve you for many years.
The hoist has a leg cover and an additional acoustic warning in the lowering phase.
The device meets the EC and EN1493 standards,
Quality 1A CE certificate for UVV. Production in ISO 9001 system
Lubricated almost all components
Low installation requirements: 150 mm flooring, concrete quality C20 / at least 25 DIN1045:. 2001 D7 (strengthened)
Safe control with low 24 V voltage in the control panel
Automatic unlocking of the security system
Automatic locking of security locks
Extremely flat approach height (105 mm)
High quality and solid workmanship
Strong aluminum electric motor, IP54
Two powerful hydraulic cylinders.
Overload protection - relief valve (overload valve),
Hydraulic emergency lowering valve in case of power failure
Low wear of the scissors joint bearing
Mechanical synchronization control
|Lifting Capacity [kg]||3000 kg|
|Lifting height max. [mm]||1000 mm|
|Lifting height min. [mm]||105 mm|
|Risinig time [s]||19 s|
|Power supply [V]||230V lub 400V|
|Engine power [kW]||2,2 kW|
|Type of drive||Hydraulic|
|Safety lock||Pneumatic on cylinder|
|Air supply [bar]||6-8 bar|
|Width [mm]||1815 mm - 1895 mm|
|Lenght [mm]||1400 mm - 2010 mm|
|Weight [kg]||550 kg|