SCISSOR LIFT PX-3500XE
POWER SUPPORT
By using an additional "short scissor" on each cylinder, the lift works at full power from the bottom without causing trouble when lifting low sports cars, which is usually a problem for standard lifts
REMOVED LOWER BAR
After anchoring the lift to the ground, we can remove one of the two lower synchronization crossbars. This enables trouble-free access from below to the supported vehicle, in particular it is useful when mounting the lift on the channel.
LOW RAMP
The ramp is only 10.5 cm high, so it's not a problem for low vehicles or vehicles with additional spoilers
ADJUSTABLE RUNNINGS
Four ramps made of checkered sheet metal make entering the lift easy.
The possibility of blocking the ramps in a horizontal position allows the lift to be extended, which greatly facilitates work on longer vehicles with support points at a greater distance.
On blocked ramps, you can set rubber blocks and support the vehicle
MOBILE SET
It allows one person to quickly move the lift without load over a hardened surface.
LIFT DESCRIPTION:
Our lift meets all the expectations of demanding users.
Its solid reinforced construction will make it serve you for many years.
The hoist has a leg cover and an additional acoustic warning in the lowering phase.
The device meets the EC and EN1493 standards,
Quality 1A CE certificate for UVV. Production in ISO 9001 system
Lubricated almost all components
Flooring requirements
Low installation requirements: 150 mm flooring, concrete quality C20 / at least 25 DIN1045:. 2001 D7 (strengthened)
Safe control with low 24 V voltage in the control panel
Automatic unlocking of the security system
Automatic locking of security locks
Extremely flat approach height (105 mm)
High quality and solid workmanship
Strong aluminum electric motor, IP54
Two powerful hydraulic cylinders.
Overload protection - relief valve (overload valve),
Hydraulic emergency lowering valve in case of power failure
Low wear of the scissors joint bearing
Mechanical synchronization control
Catalog number | PX-3500XE |
Lifting Capacity [kg] | 3500 kg |
Lifting height max. [mm] | 1000 mm |
Lifting height min. [mm] | 105 mm |
Risinig time [s] | 19 s |
Power supply [V] | 230V |
Engine power [kW] | 2,2 kW |
Type of drive | Hydraulic |
Synchronization | Stała |
Safety lock | Elektryczny |
Width [mm] | 1820 |
Lenght [mm] | 2020 |
Weight [kg] | 600 kg |
* Required fields
Four-post lift PK4-CARPARKZN. It is a hydraulic powered lift with manual release of the safety locks in the columns. The platforms are synchronized by means of steel ropes. The lift will be used in every car workshop for servicing passenger cars, off-road SUV and light commercial vehicles. It is perfect for repair or diagnostic work. This lift is also...